Шнайдер C10F32D100: Автоматический выключатель в литом корпусе ComPacT NSX100F

1. Интерпретация модели

C10F32D100 is the complete order code of Schneider’s new-generation ComPacT NSX series автоматические выключатели в литом корпусе. The meaning of each segment is as follows:

1. Основные технические параметры

Основные параметры

MicroLogic 2.2 Trip Unit Parameters

Physical and Electrical Characteristics

III. Функциональные особенности

1. Комплексная защита: Provides three-stage protection including long-time delay, short-time delay and instantaneous protection, effectively preventing overload and short-circuit faults.
2. Precise Control: Compared with thermal-magnetic trip units (TM series), electronic trip units offer more accurate protection curves and adjustable parameters.
3. Status Visualization: MicroLogic 2.2 is equipped with LED display for real-time monitoring of current and fault status.
4. Модульная конструкция: Supports a variety of accessories (вспомогательные контакты, контакты сигнализации, расцепитель минимального напряжения, и т. д.) for flexible installation.
5. Environmental Friendly: Schneider Green Signature design, reducing energy consumption and carbon footprint.
6. Easy Operation: Ergonomic handle for labor-saving operation; front-mounted accessories reduce wiring time by 40%.
7. Сценарии применения
8. Industrial Power Distribution Systems: Used as main switch or branch switch to protect motors, transformers and distribution lines.
9. Building Electrical Systems: Low-voltage distribution cabinets in commercial buildings and industrial plants.
10. Центры управления двигателем (МСС): Protect three-phase motors from locked rotor and overload conditions.
11. Дата-центры: Power protection for critical loads to ensure power supply continuity.
12. Новая энергетика: DC-side protection of photovoltaic inverters and energy storage systems (additional configuration required).
13. Product Comparison

Comparison with Trip Units of the Same Series

Comparison with Chint Alternative Models

1. Рекомендации по выбору и использованию
2. Ключевые моменты выбора

Select protection curves according to load types: for motor loads, it is recommended to set short-time delay to 5-6×Iu

Breaking capacity should be greater than the expected short-circuit current of the system

Consider future expansion; rated current should be slightly higher than the actual load current

2. Меры предосторожности при установке

Ensure the mounting surface is flat and the tightening torque meets requirements (screw torque 25N·m)

Corresponding cable lugs must be used for terminal connections to avoid heating caused by poor contact

Leave sufficient heat dissipation space around and avoid close installation with heat-generating components

3. Рекомендации по техническому обслуживанию

Регулярный осмотр (at least once a year): появление, tightness status, flexibility of operating mechanism

Check contact condition after short-circuit tripping and replace if necessary

Clean with dry compressed air to avoid moisture and dust accumulation

VII. Руководство по устранению неполадок