LUST CM-DPV1.3.0 Detailed Specifications

LUST‑CM‑DPV1.3.0: Modul de comunicare LUST PROFIBUS‑DP

(PROFIBUS-DP Communication Module)

CM-DPV1.3.0 is a PROFIBUS-DPV1 communication module designed by LUST (later acquired by Lenze) specifically for C-line series drives. Below are the complete technical specifications and functional features.

Model: CM-DPV1.3.0 (also marked as CM-DPV1,3.0)

Tip de produs: PROFIBUS-DP Slave Communication Module (supports DPV1 extension protocol)

Applicable Drives: CDA3000 Inverter, CDD3000 Servo Controller, CDE/CDB3000 Position Controller, CTC3000 Direct Drive Controller

Software Version: Commonly V2.25-00 (upgradable via DriveTop)

Replacement Model: CM-DPV1.3.1 (hardware compatible, software optimized)

Lenze Replacement: EMF2177IB (fully functionally compatible)

Articol	Caietul de sarcini
Tensiune de alimentare	18–30 V DC (powered by drive backplane)
Max. Operating Current	0.25 O
Interfață de comunicare	PROFIBUS-DP (9‑pin D‑sub, compliant with EN 50170)
Baud Rate	9.6 kbps / 19.2 kbps / 45.45 kbps / 93.75 kbps / 187.5 kbps / 500 kbps / 1.5 Mbps / 3 Mbps / 6 Mbps / 12 Mbps (auto‑detection)
Slave Address Range	1–125 (set by DIP switches S1/S2 or parameter 582‑PBADR)
Process Data (PZD)	Intrare: max. 244 bytes; Ieșire: max. 244 bytes
Acyclic Data (PKW/DPV1)	Supports parameter read/write, diagnostics, firmware upload
Clasa de protectie	IP20 (installed inside the drive)
Temperatura de operare	0–55 °C
Temperatura de depozitare	-25–+70 °C
Dimensiuni	Aproximativ. 90 × 90 × 30 mm (for C-line communication slot)
Greutate	Aproximativ. 0.16 kg

Cyclic data exchange (PZD): real-time control word, setpoint, status word, actual value

Acyclic data exchange (PKW): parameter read/write, diagnostics, firmware update

Extended diagnostics: detailed network/module/drive status, fault codes

EasyDrive Mode: standard PZD structure (control word / status word + setpoint / actual value)

ProfiDrive Mode: compliant with PROFIdrive profile, suitable for standard PLC configuration

Bus status, module status, communication errors, drive faults

Supports PROFIBUS standard diagnostic messages and extended diagnostics

Hardware: address setting via DIP switches, X13 interface coding

Software: parameter configuration via LUST DriveTop / Lenze Engineer, GSD file configuration

GSD File: LUST08E9.GSD (standard version)

Locația de instalare: Dedicated communication slot for C-line drives (no extra wiring needed)

Compatibilitate: Hardware compatible with CM-DPV1.3.1, înlocuire directă

Configuration Tools: DriveTop (LUST), Engineer (Lenze)

Supported Systems: Mainstream PROFIBUS masters such as Siemens, Schneider, ABB

Automated production lines, robot systems, packaging machinery, printing equipment, material handling

Industrial automation systems requiring PROFIBUS-DP centralized control, parameterization and diagnostics

Ştiri Știri comerciale