Контактор,автоматический выключатель,датчик,Кодер,ПЛК,Конвертер
История бренда: Бывший Metso Neles, now part of Valmet. The ND9000 series is a high-end double-acting, intrinsically safe HART smart valve controller for closed-loop positioning of pneumatic control valves.
- Пояснение кода модели
ND9203: ND9200 series, double-acting, HART protocol smart positioner
HE: Enhanced high-precision Hall feedback module
1: Intrinsically safe Ex ia IIC T6 Ga, suitable for hazardous areas Zone 0/1
Сравнение: ND9203HE8 is flameproof type (Зона 1/2), do not mix up.
- Основные технические характеристики
| Элемент | Спецификация |
| Входной сигнал | 4–20 мА постоянного тока, loop-powered, ХАРТ7, внешний источник питания не требуется |
| Actuator Compatibility | Double-acting pneumatic actuator; linear stroke 3~120mm, rotary stroke 0~95° |
| Air Supply Pressure | 0.14~0.8 MPa (1.4~8 bar), standard instrument air |
| Positioning Accuracy | ±0.1~±0.2% FS, extremely low hysteresis |
| Взрывозащита | АТЕХ / IECEx Ex ia IIC T6 Ga, искробезопасный |
| Класс защиты | IP66 / NEMA 4X |
| Рабочая температура | -40℃ ~ +85 ℃ (optional Arctic low-temperature version down to -53℃) |
| Valve Position Sensing | Non-contact Hall sensor, отсутствие механического износа |
| Сертификация | уровень безопасности 2 (IEC61508) |
| Материал корпуса | Anodized aluminum alloy housing with local LCD and knob operation |
| Масса | Приблизительно. 2.8 кг |
| Air Connection | Г1/4 (NPT1/4 optional); Electrical port M20×1.5 |
- Ключевые особенности
- Automatic Calibration: One-shot auto-tuning, supports quick single-point calibration, hot-swap capable
- Advanced Valve Diagnostics: Valve characteristic curve, friction, гладить, differential pressure and equipment temperature monitoring, регистрация событий, predictive maintenance enabled; compatible with Neles FieldCare, FDT/DTM and EDDL
- Piezo Pilot Valve: Extremely low static air consumption, energy saving and fast response
- Local HMI: LCD display with buttons for on-site configuration, diagnostic viewing and operation permission lockout
- Configuration for Direct/Reverse Action & Flow Characteristic: Linear / Equal Percentage / Quick Open, customizable
- Valve Position Alarm and Fault Current Setting (FDE Fault Position Output)
- Типичные сценарии применения
нефтехимическая, масло & gas refining, coal chemical, power plant and fine chemical industries; hazardous explosive areas for linear and rotary double-acting control valves (preferred match for Metso Neles control valves).
- Установка & Руководство по вводу в эксплуатацию
- Installation standard: Comply with VDI/VDE3845, minimize backlash of valve feedback linkage
- Air supply requirement: Dry and clean instrument air, filtration ≥5μm, oil-free and water-free
- Электропроводка: Intrinsically safe circuit must be fitted with safety barrier; IS cable routed separately, not in the same tray as power cables
- Calibration procedure: Supply air → connect 4mA/20mA signal → start auto-tuning routine, verify dead band and hysteresis after completion
- Коммуникация: Use HART communicator or FieldCare to read valve diagnostics and modify parameters
- Common Troubleshooting Checklist
Position oscillation: Unstable air supply, over-sensitive PID parameters or excessive actuator friction; reduce gain or increase dead band
Valve position fails to follow setpoint: Loose feedback linkage, insufficient air supply, blocked piezo pilot valve or excessive voltage drop across IS safety barrier
HART communication failure: Insufficient/excessive loop load, reversed polarity or improper shielding earthing of cable
Сигнализация: Valve stroke out of limit, differential pressure alarm or internal overtemperature
- Альтернатива / Similar Series Reference Models
ND9203HE8: Same performance, flameproof type, alternative to HE1 for Zone 1/2 только
ND9103HX: Basic HART version, standard non-enhanced feedback, slightly lower accuracy
ND9206HE1: Intrinsically safe same as HE1, compatible with actuators of larger torque
